Hi All!
As you remember, I managed to broke
my spar pip pin. After all, I have adjusted
things from there and there and now all
the three (x2) bushes (cpm, 2xspar) are exactly
in same line and parallel with each others.
Today I managed to rigg her easily and spent less
than 5 minutes and did it totally alone. I was able
to insert my (rented from Jos so far) spar pip pin by
my one hand only and w/o hammer.
The order between pins was also important:
1) port spar in
2) both pins half way
3) stbd spar in
4) pip pin fully inserted
5) plain pin fully inserted
Many thanks for all the tips I got.
I hope this will help some of you also.
Regards,
Raimo M W Toivio
OH-XRT #417
OH-CVK
OH-BLL
37500 Lempaala
Finland
tel + 358 3 3753 777
fax + 358 3 3753 100
gsm + 358 40 590 1450
raimo.toivio@rwm.fi
www.rwm.fi
|