Hello all,
We have found (unfortunately) that the best way to remove old Spraylat is to use
a 50%/50% mixture of acetone and mineral spirits to help soften the coating.
Care must be taken to not have too high of concentration of acetone otherwise
it can create a haze on the window. It is best to try on a scrap piece of window
material to test the compatability. Again, prevention is the best course,
a minimum of 4 coats applied, with each additional coat applied just as the
previous
coat has dried enough to brush/spray without deforming the previous coat.
Removal and replacement should be done annually at the very longest, and
preferrably
every 6 months.
Regards,
Rob Huntington
Phoenix Composites
4863 E. Falcon Dr.
Mesa, AZ 85215
ph (480) 924-9750
email robertodue2002@yahoo.com
---------------------------------
|