John,
You can check my Forum web site for some details on the installation of
the Graham Singleton Rudder and Tailwheel Drive Mod. I have pics of
the hardware and various aspects of the installation. There isn't a
single place I can point out as the installation is scattered through
the build. But, you can start looking at Year #3, Q 1, 2004 on page 1
half way down the page where I show the parts. The installation occurs
---From there on.
I hope this helps. With your build.
Good building and great flying,
Bob Borger
Europa Kit #A221 N914XL, XS Mono, 914, Airmaster C/S
http://forum.okhuijsen.org/N914XL
(75%) tail kit done, wings closed, cockpit module installed, pitch
system in, landing gear frame in, rudder system in, outrigger mod in,
Fuselage Top on, lift/drag/flap pins in, wing incidence set, tie bar
in, flap drive in. Working in - 24 Instrument Panel, 25 Electrical, 27
Setting Wings, 28 Flaps, 29 Main Gear, 30 Fuel System, 32 Tail, 34 Door
Latches & 35 Doors, 37 Finishing.
3705 Lynchburg Dr.
Corinth, TX 76208
Home: 940-497-2123
Cel: 817-992-1117
|