All,
The hose clamp type probes that came with Grand Rapids EIS (for my 912S)
will have the probe tip very close to the pipe wall opposite to where they
enter the pipe. Ideally, a probe tip should be closer to the center, I
assume, but maybe the sensor here goes over more of the length of the probe
(have asked GR, but no reply yet).
Any experience with these EGTs that may be shared?
Any special consideration when fitting them, other than abt. 70 mm from
flange and maybe using a counter-sink bit to get a larger contact surface
between the pipe and the probe where it goes through?
Regards,
Svein
A225 - now in Norway
|