Gidday,
I am interested in sourcing a couple of templates, ideally tracings of the
TGW1 component on the Trigear flap to wing bracket. This component is a
strap that has a slot in it, and it ensures the flaps don't drop beyond
full down when disconnected from the aircraft. Also, if someone might
respond to this might also be able to draw around the outer of the TGW21,
the fulcrum brackets I'd appreciate it. I have a fax machine if that helps,
or an attachment would be great. Thanks in anticipation.
Reg
Tony Renshaw
Sydney Australia
Classic 236 B.B. Taildragger
Currently working on Rudder Pedals,
In but tight so more work to go on them.
Tail, Wings, Ailerons, Flaps Complete and Connected
Lower Fuse in Jig,
Tail Torque Tube installed with temporary timber dowels.
Mass Balance assembly installed and deflections sorted
Roof Panel between doors completed.
Photos at:
http://forum.okhuijsen.org/TonyR
Intended Engine: 912S CS prop (model undecided)
Instrumentation: Garmin 296 Colour GPS beneath an electronic Artificial
Horizon, one that I can trust for short periods IMC, to get out of a sticky
situation
|