In a message dated 28/11/04 01:25:34 GMT Standard Time,
graham@gflight.f9.co.uk writes:
> could it be your gear mount weldment is not symmetrically installed? Start
> by checking that, then work downstream to find what caused the problems.
> Friend of mine just alleviated his similar calliper problem by softening
> the tunnel with a hot air gun and bulging it out to clear, but also cut a
> slot in the thigh support to allow the tunnel side to move out a bit, then
> did the simple repair to restore the strength of the assembly
Graham
Thanks for those suggestions. Using a hot air gun is a novel approach I had
not considered. I did check the gear mount weldment and it is symmetrically
installed.
John
XS Monowheel kit 536 G-JHKP
|