Ken,
Take a look at http://europa363.versadev.com/ under June 2001, you will see
a check list.. I did have to change a few things recently. I had to move
the transponder antenna down the back onto the floor behind the mass balance
arm and I had to move the VOR / Localizer antenna to the roof to get the
localizer to work properly. The comm., VOR & transponder antenna's were all
made by Bob Archer.
If you have the aircraft set up securely in a cradle you can do leave off
bonding on the top for quite a while. I did all of the wing incident setups
and flap setup before putting the top on.
To give you some idea, I found it an easier task than bonding in the cockpit
module
Paul
|