Hi All,
Would someone who is not too far through their build mind taking a couple of
measurements
for me. I need to know the OD and thickness of the tube that passes
under the cockpit module. In addition I need to know the OD of the push rod
that passes through the middle of it. I am going to try and fabricate a seal
between the two tubes.
Why, well I get a fair amount of air coming from the spar area into the cockpit
through this tube, and although my Mr. Leatherman boots seal off a bit of it,
its not enough. The outside air temperatures here in the northern mid west are
now at around 10 degrees F, and I expect it to get worse. Even a small amount
of air from this area is pretty darn cold. I have pretty well stopped flying
the aircraft until I can solve this problem.
Thanks, Paul
|