Hi again folks.
I got the outrigger wheels and also a sealed tail wheel from: Linco.
www.linco-inc.com email: linco@flash.net
Sorry, I can't find the invoice with the product # but you can figure out
what you want. My tail wheel is a #5.00006.565 6"x2" ball bearing (sealed)
round tread.
I have the original supplied outrigger and tail wheels (XS) for a Santa
special price of FREE!
Merry Humbug!
Tom XS Jab Airmaster N96V Atascadero, CA
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of
beecho@beecho.org
Subject: RE: Europa-List: Outrigger wheels
I have a source for the softer, quieter sealed bearing wheels as advocated
by Dennis Voorhees. I have to look in my records and will do so and post.
They can be ordered on line. Tom Friedland
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Ronald J.
Parigoris
Subject: Re: Europa-List: Outrigger wheels
--> <rparigor@suffolk.lib.ny.us>
Hello Jim
"Does anyone know of a source for the outrigger wheels"
I am not flying yet. Here is a post I made 01-2004
I finally got around to installing Colson 4" x 4.25" Gray Flat profile
Hi-Tech Performa. They have ball Bearings and a 3/8 hole. They are not
sealed ball bearings.
I forget who I told I would report to when I figured out how to make a
spacer/dirt shield for the bearings.
I used 18-8 SS 3/8-24 2.5 length Hex cap screws. McMaster PN 92198A361
www.mcmaster.com
and 18-8 thin Nylon Insert Locknuts McMaster PN 90101A245
I needed to drill outrigger forks to 3/8 hole.
I made the spacers out of 1.25 inch aluminium bar.
Dimensions of spacer:
1.010" OD
3/8 hole through center.
Pocket .165" deep and .935 ID
I actual made the Pocket depth ~.175, and fit exact to wheels by sneaking
off a few thousands at a time.
The seal is going to keep out dirt pretty good.
Overall completed weight is probably very similar to the stock, perhaps a
bit lighter.
I purchased from:
Thank you for the inquiry
Rich
Pooley Inc
800-428-2606
716-852-3780
716-852-3788 fax
Ron Parigoris
I am thinking on Glider Wings to use In Line skate wheels:
Anyone ever try Inline skate wheels as a replacement for outrigger wheels?
Check out 100MM ones here:
http://www.nettracing.com/wheels.htm
I am sure you can get sealed BBs for them.
Ron Parigoris
advertising on the Matronics Forums.
--
Checked by AVG Anti-Virus.
--
Checked by AVG Anti-Virus.
advertising on the Matronics Forums.
--
Checked by AVG Anti-Virus.
--
Checked by AVG Anti-Virus.
|