In fairness to the factory, I think that solution was applied worldwide!
Andrew, if Mike can't find those instructions, I'm sure that if you contact
the new factory, Andy will email them to you.
I'm not sure I'd like to fly in the one with the moved joggles on the
ribs... That bump is there for a reason :-(
Kind regards,
Jeremy
Jeremy Davey
Europa Monowheel 537M G-EZZA
Europa Club Vice-Chairman, Webmaster, PFA NC Representative
PFA EC Member
"If you can keep your head when all about you are losing theirs, then it is
possible you haven't grasped the severity of the situation."
Tail done
Standard XS wings with mods underway
CM installed in fuse (with airbrakes fittings)
1250 build hours to date
Intended fit:
Rotax 914 turbo, Airmaster CS fully-feathering prop
Lots of lights, buttons, switches, gizmos, and alarms
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of
DuaneFamly@aol.com
Subject: Re: Europa-List: Wing top skin strip does not line up with joggle
Andrew,
That was one of the OOPS! that was found in many of the kits sold. Here in
the States, the company had us remove the section of reinforcement on the
skin
and add a strip of foam covered by two layers of BID. I may still have the
written instructions if you need them.
I remember one builder that just repositioned the joggles at each rib.
Mike Duane A207
Redding, California
XS Conventional Gear
Just about to put the top on but still finding little things to do before
that.
|