Dave,
I can't recall the correct bit of tufnol, but I'd like to share with you how
I went about it. I put the wings on and then got a block of tufnol and
slowly reduced its thickness until it was a snug fit between the spar and
the CS15 bracket. I then removed the wings, roughed up the aluminum and
bonded it in with redux. Now when I install the wings they are held
precisely at the right height for the spar pins.
Paul
----- Original Message -----
From: "David Simenauer" <dsimenauer@cox.net>
Subject: Europa-List: Pads for CS15
>
> The diagram in my manual shows a phenolic pad on the face of the CS15
quick connect bellcrank for the ailerons. However nowhere can I find in my
manual any instructions for attaching this pad or even a part number. I
have found a piece of Tufnol, part number euro8 that is 83mm x 75mm x 1mm
thick. This seems like the pad. Is this indeed the pad and should I attach
it to the CS15 with a bit of Araldite.
>
> Thanks,
> Dave Simenauer
>
> A101 Trigear
|