Subject: | Re: Europa-List: Squeezing solid rivets |
---|---|
From: | SPurpura@aol.com |
Date: | Fri, 14 Jan 2005 21:00:37 |
In a message dated 1/14/2005 1:15:37 PM Pacific Standard Time, asarangan@YAHOO.COM writes: You can draw rivets directly through thin metal without prepunching a hole. Thin metal slugs drop out of the outlet hole on the side of the tool. USE AS DESCRIBED IN THE FULL TEXT EXEPT IGNORE (You can draw rivets directly through thin metal without prepunching a hole. Thin metal slugs drop out of the outlet hole on the side of the tool.), AS THIS IS NOT SUITABLE.ONCE YOU SEE THE TOOL ITS USE IS OBVIOUS. SAM N77EU |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Europa-List: Re: Europa-List Digest: 30 Msgs - 01/12/05, N55XS |
---|---|
Next by Date: | Re: Europa-List: Squeezing solid rivets, MICHAEL PARKIN |
Previous by Thread: | Re: Europa-List: Squeezing solid rivets, Andrew Sarangan |
Next by Thread: | Re: Europa-List: Squeezing solid rivets, MICHAEL PARKIN |
Indexes: | [Date] [Thread] [Top] [All Lists] |