To whom it may concern:
The following remarks are in reply to a question about Graham
Singleton's
mod PFA 10371 which uses the original pushrod to add to the revised longer
tailwheel spring mod.
I lost the query message regarding the above subject and made a point to measure
the requisite parameters next time. I suppose being late in reply it's
redundant,
but wanted to appear keen:
The simple rod length (no ends 14
inches
add the rodends AN490HT8P shoulder-shoulder 14-1/4 inches
distance twixt endfitting centrelines MW4 18 inches
Strangely enough these distances are measured to the nearest mm, in
situ,
give the requisite 30deg either side travel, and permit about 3/4in in rod
length change if required - that is, the rodends and fittings are at mid-range.
Cheers,
Ferg
A064
sandingsandingsanding
|