Silly question perhaps but why did you not decide to use the built in
intercom that the IC200 has.
I have the wiring disgrams and will look at it if you like but suspect they
will be the same as yours.
For reasons I wont go into on the board I am now wanting to install a
separate intercom so any information you can get would be of interest.
BTW who is your intercom made by.
----- Original Message -----
From: <owner-europa-list-server@matronics.com>
Subject: Europa-List: Wiring Intercom/VHF Comm.
>
> Hi all.
>
> I have ended up in a corner in my futile attempt to connect my PM1000
> Intercom to the radio/aircraft systems. The wiring diagram for the
> Intercom is clear enough, but the diagram for my ICOM -A200 is at a loss
> to describe "Phone Hi" or "Phone Lo" - or "Mic Audio Lo"/"Mic Audio Hi" on
> the Molex connector. For example, Pin # 17 on the PM1000 should be
> connected to "AUX Headphone Jack" and branched to "Aircraft Radio Phone
> Hi" - while pin # 4 should go to the same jack and branched to " Aircraft
> Radio Phone Lo".
>
> During my search I contacted Icom's technical support, but to no
> avail, they were not able to answer my queeries. Thus my humble question
> to the knowledgeable among you: Which pins on the ICOM Molex Connector
> should be used for these wires?
>
> Cheers,
> Hans. #334 in Norway. hansjd@online.no
>
>
>
|