Peter
Don't forget the factory is fully back in business and supplying all parts
needed. I would think that supply from the factory would be much cheaper
than the real cost of making a disc from scratch.
Ian Rickard #505 G-IANI XS Trigear
Europa Club Assistant Mods Rep
e-mail mods@europaclub.org.uk
or direct g-iani@ntlworld.com
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com]On Behalf Of Christine
and Peter Timm
Subject: Europa-List: Mono Wheel Brake Disk
<cptimm@telus.net>
While conducting my Annual I discovered that the rotor on my wheel was quite
distorted (wobbly). I have removed it and taken it to a machine shop but
the distortion, caused through uneven heating, is too great to remove by
lathe. My question is, where are these rotors made or what type of steel
should I use to have a new rotor made? Thanks in advance for your
suggestions .
--
Cheers,
Peter Timm
Europa Classic Mono
C-GIET, Pemberton, British Columbia.
|