1.64 REPLY_TO_EMPTY Reply-To: is empty
0.10 TO_EMPTY To: is empty
hi all , ive got the usual rotax 912S with the standard supplied stainless
exhaust
, trouble is i can only get 3 out of the 8 springs to fit . ive welded up
a spring puller and even using that tool with the springs fully compressed they
are about 1/4" ( 5mm ) too short to reach over the tangs. europa refered me
to the manufacturer - they tell me that the springs should be fitted with the
pipe off the cylinder head , and then lever the pipe in to place - it sounds
like
a potch . has any one any light to throw on this as leavering a pipe with
2 springs on it against alloy sounds like a nice set of gouge marks at the end
.
cheers , steve # 573
----------------
Visit EuropaOwnersForum http://www.europaowners.org/
|