Hello Patric
You said that you recent did a full refurbishment of your 914. Was a major
overhaul done to it?
First off was it running OK before you did refurbishment?
Check that the carb cables are rotating freely at the carb, and as Cliff
mentioned check with a set of gages. you need to disconnect the cross balance
tube, a good place to connect gages......etc.....
Dear Ron,
Many thanks for your comprehemsive and very helpful list of suggestions.
Most of the things which you list have been done but there are some which I
need to look at again in the light of your comments.
I will let you know if and when the problem is solved and what had to be
done.
Thanks again.
Patrick
|