Craig,
You are in the wrong part of the TLR 43 programme. You need to select
'monitor', where the throttle position is indicated - 0% to 115%.
Set up your throttle stops Max, Max Continuous and Idle using this position
indicator.
regards,
Mike
----- Original Message -----
From: "Craig Ellison" <craig.ellison2@verizon.net>
Subject: Europa-List: 914 throttle stops
> <craig.ellison2@verizon.net>
>
> All 914 builders and flyers,
>
> I attempted to do throttle calibration yesterday and also set the stops
> for
> max power(100%) and take-off(115%). The Europa install manual for 914
> says
> there are detailed instructions in the Rotax install manual. I couldn;t
> find any but went ahead anyway. The program page asked for idle and max
> throttle settings and that was it and said the calibration was complete.
> My
> question is how do you set the max contunuous thrattle setting? And is it
> done with the computer or with RPM and engine running?
>
> BTY I did start the engine for the first time. She caught on the first
> blade and ran very smooth at 1800rpm and above. Carb bal. is next.
>
> Thanks for any and all input.
>
> craig ellison
> A205
> ----- Original Message -----
> From: <NevEyre@aol.com>
> To: <europa-list@matronics.com>
> Subject: Re: Europa-List: Close Out Flanges
>
>
>>
>> Hi Jim and Heather,
>> Look carefully at the foam cores, they should have been cut, for the
>> closeout pieces, they may have ''fused'' themselves back on.
>> Failing that, check with Andy for the length of the cores before you trim
>> any more off.
>> Cheers,
>> Nev.
>>
>>
>>
>
>
>
|