Mike et all.
I think I purchased it from Allied Electronics see:
http://www.alliedelec.com/Search/ProductDetail.asp?SKU=642-2273&desc=26PCA
FA6D
The rest of the components came fom Digikey,
What would help everyone on the list is if someone would invest the time in
laying out a printed circuit board. A PCB would make it so even the most
faint hearted could successfully build this.
Paul
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com]On Behalf Of Tony
Krzyzewski
Subject: RE: Europa-List: Fuel sender etc.
Ps
For those using my pressure sensor chip set there is a new low cost
prototyping board available for USD10 + p&p
http://www.kiwacan.co.nz/products/kpic/kpic-2840p.shtml
This board has a lot of the processor, timing and serial interface
related circuit board already laid out which will result in an easier
build of the pressure sensor. I have to build up another unit for myself
for a domestic water tank and I'll be using this board to build up the
circuit. Once I have done this I'll add some as built photos to the
existing documentation which can still be found at
www.kaon.co.nz/europa/fuelgaugev3.pdf
Regards
Tony
|