Jim,
I also am building the MG wings and will be watching closely the
responces you get. In addition, I am quite confused by the wing trailing
edge finishing, but will get to that in time. Currently working on the
airframe having just mounted the engine. ;)!!
Ralph
RK Hallett III
Reno, NV usa
im Butcher wrote:
>
>When preparing to install the GA 02 plates, do you cut away the entire top
>flange
of the close out to allow the GA02 to slide in, or do you attempt to cut a
slot at the in the flange of the close out and twist GA 02 into place? (I have
issue 2 page 7-6 of the manual. Looks like one would cut the flange shown
in Fig 13).
>
>BTW, this same page refers to removing a large part of the leading edge to
>provide
clearance for the aileron push rod. No where in my manual is the further
mention of the installation of the aileron push rod. Can someone refer me to
a source of this information? I downloaded the MG manual from the Europa US
website. No manual came with my MG kit.
>
>Thanks
>
>Jim Butcher
>
>
>
>
|