Simon,
I would encourage you to take a look at the Ground blocks offered by B&C.
Take a look at
http://www.bandc.biz/cgi-bin/ez-catalog/cat_display.cgi?26X358218 and scroll
down the page.
I used a 48 tab block on the inside of the firewall and a 24 pin on the
engine side. The ground blocks were bolted together with a brass through
bolt. Using this type of approach gives you a single point ground for
everything, and its the first step to keeping ground loops out of your
system. This is where I grounded my fuel pumps to.
Regards, Paul
|