I used a 12 inch long drill bit, once started you can make it curve slightly
to miss the Tank inlet,
works a treat!!
The other way is to use a pancake drill attachment, they work well in
confined places, Check out Ebay for used ones,
Item number 4441300173
regards
Ivor Phillips
----- Original Message -----
From: <UVTReith@aol.com>
Sent: Friday, February 17, 2006 3:48 PM
Subject: Europa-List: Tie-Bar / Gusset Plate Assembly
>
> Hi friends,
>
> Maybe I have made something wrong.
> The tie-bar is installed, the plywood blocks too (builder manual page
> 7-6 -
> 27-8).
> Now I would like to fit the gusset plates, but I see no way to drill on
> the
> right side the outer holes through the plates, tie-bar and plywood block,
> as
> there is a tank stud in my drilling line.
>
> Is there somebody out in the world, who could give me a clue how to solve
> this problem.
>
|