I had a clearance problem in both of my wings. I shimmed the bellcrank
out with two .063" shims and trimmed out the holes in the ribs. All is
well with 140 hours in the air...
Jeff - N55XS
141 hours...
Keith Hickling wrote:
>
> I have just installed the aileron bellcrank assembly on the stbd wing of my
> XS,
with the long arm of the bellcrank towards the spar as shown in the manual.
There is around 6 mm clearance between the front of the bellcrank arm and the
spar, but I have had to trim the holes in the double rib for the aileron pushrod
right back to spar, and the pushrod is still rubbing quite hard on the front
end of the double rib that is bonded onto the spar (the double rib seems to
be formed as one unit joined at the spar end).
>
> I find this worrying because the bellcrank assembly presumably has constant
> dimensions
and is mounted on the spar, so if mine binds on the spar, it should
always happen unless I have goofed and assembled it the wrong way. Should it be
mounted with the long arm towards the spar? Have others had to sand back the
glass between the double rib that is bonded to the spar? The alternative would
be to pack out the mounting brackets with washers, but I feel this shouldn't
be necessary.
>
> Help please!
>
> Keith Hickling
>
> Tail, ailerons, flaps completed
> Wing reinforcements and W18 plates installed
> working on cockpit module
> 8 months into build
>
>
>
>
>
>
>
>
>
>
>
>
>
>
--
|