Good Mornin Al,
I just installed door pulls on both doors. I drilled a hole from the
outside, filed slots on both sides of the hole in order to insert a fender
washer
using a hemostat, then inserted a screw and tightened it. Afterwards, I filled
the holes with flox mix until it was just above the hole and then covered it
with piece of plastic sheet that was stiff enough to stay flush with the
surface. This gave the final result a smooth flush finish that should not be
noticeable when painted.
I sent two pix to your address for clarification.
Mike Duane A207A
Redding, California
XS Conventional Gear
Jabiru 3300
Sensenich R64Z N
Ground Adjustable Prop
|