Bob,
I had problems getting my calls to go through, over the past few days.
Not a Euproa thing, but apparantly communications problems between our
respective countries. I sent John Wheeler an email, asking him to call,
when he could. Two days later I got the call, made my order and chatted
with John for a few minutes. It appears that they have been very busy,
of late, what with Andy leaving and getting the new engineer up and
going. I have had problems reaching them, in the past, via email, but
faxes seem to get a prompt response. Try a different mode of
communication...
Jeff - Baby Blue
189 hours
rlborger wrote:
> Europaphiles,
>
> What's with E'04? Over the last couple months I have placed several
> orders for various parts/components and have asked some technical
> questions. I have not even received a simple reply or
> even acknowledgment. What's with them? I trust they aren't in trouble
> again? If anyone happens to be in the shop would you please give them a
> swift kick in the a** for me.
>
> Thanks,
>
> Bob Borger
>
> Europa Kit #A221 N914XL, XS Mono, Intercooled 914, Airmaster C/S
>
> http://www.europaowners.org/N914XL
>
> (85%) tail kit done, wings closed, cockpit module installed, pitch
> system in, landing gear frame in, rudder system in, outrigger mod in,
> Fuselage Top on, lift/drag/flap pins in, wing incidence set, tie bar in,
> flap drive in, Mod 70 done. Baggage bay in. Working in - 24 Instrument
> Panel, 25 Electrical, 28 Flaps, 29 Main Gear, 30 Fuel System, 32 Tail,
> 34 Door Latches & 35 Doors, 37 Finishing. Airmaster arrived 29 Sep
> 05. Seat arrived from Oregon Aero. Preparing ROTAX 914 for installation.
>
> 3705 Lynchburg Dr.
>
> Corinth, TX 76208
>
> Home: 940-497-2123
>
> Cel: 817-992-1117
>
>
>
>
> ------------------------------------------------------------------------
>
--
|