Cheers,
I am looking at a square cutting on three sides with the usual
crack control drill hole at each end. This +/-2inch cutting carries no
infromation in the manual that I can find - but perhaps I've missed the
reference.
It would appear to permit access to the turbo control area
further back OR provide cooling air to a certain facility.
If you know of its purpose, or have divined same from superior
research - and are able to take a moment to explain - I would appreciate the
knowledge, as am about to finalise the fitting of the engine and its
accessories.
Much obliged in advance,
Ferg Kyle
Europa A064 914 Classic
|