Correction - the cable is of-course between waste-gate and servo-
unit..... :-)
Gert
Den 26/07/2006 kl. 11.07 skrev Gert Dalgaard:
> Check your bowden-cable between TCU/Wastegate.....
> Special attention arround exhaust-area.
> Have had the same problem and that was caused to a hot-spot on the
> backside of the bowden where it was routet to close to echaust#3.
> regards Gert
> #151 / OY-GDS
>
>
> Den 26/07/2006 kl. 10.41 skrev Simon Smith:
>
>> Someone recently suggested MouseMilk oil (available from LAS) as a
>> cure.
>>
>> Simon
>> -----Original Message-----
>> From: owner-europa-list-server@matronics.com [mailto:owner-europa-
>> list-server@matronics.com] On Behalf Of Ray Stevenson
>> Sent: 26 July 2006 08:57
>> To: 'europa-list@matronics.com'
>> Subject: Europa-List: Turbo problems 914 - Help!!
>>
>> We have a Europa 914 turbo and are experiencing intermittent high
>> boosts. So far we have pointed the finger at the wastegate failing
>> to open and close properly. Could this be the only way this
>> problem could occur? We have checked that the servo motor is
>> functioning correctly and also checked all the wiring joints to
>> it. Has anyone else had similar problems? If so we would welcome
>> any suggestions. - Ray
>>
>>
>
>
> E mail: lgds@post6.tele.dk
> http://home19.inet.tele.dk/dalgaard/oygds.jpg
>
>
| 