Al, not likely that the CM is set back, as it must be in contact with
the firewall. More likely, the flap pins are positioned improperly.
The only way I can see to remedy the problem would be to relocate them
and that will be no small task. Good luck and let us know how it turns
out...
Jeff - Baby Blue
209 hours...
astills wrote:
>
>
>Thanks for the answers. The alerons are spot on and both flaps are approx
>1/4"-3/8" low on both sides. Both the same.
>The flaps match up with the training edges and the alerons the same. They
>just don't match up to each other. When I bought my kit from a fellow in
>California, he had already installed the cockpit module so I'm not sure if
>he had moved the module
>back a slight amount or not. As the electric motor runs the flap bar up it
>has a hard stop on the back of the module.
>Al Stills
>N625AZ
>
>
>
>
|