Does anyone know what the correct ACS part number for an equivalent to the
Europa Fiberglass cloth?
_____
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Alan Burrows
Sent: Thursday, March 22, 2007 20:10
Subject: RE: Europa-List: Life is so unfair!
Thanks John
The aircraft is presently with Bob and I am awaiting his findings. At that
time we will know more.
Cheers for now
Alan
_____
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of
TELEDYNMCS@aol.com
Sent: 22 March 2007 23:18
Subject: Europa-List: Life is so unfair!
Hey Alan,
My first tank came from the factory with a flaw in it. The tanks, as I was
told, are rotomolded. What look like seams on the tank are actually molding
lines. Mine had a molding flaw, likely caused by not enough material being
put into the mold at the time the tank was cast, and that caused a hole in
it that was about the size of the end of your little finger. The hole was
hard to see because it was covered over with a paper thin layer of plastic.
I would have never noticed it except for the fact that I pressure tested the
tank with air after I drilled out the boss's in a combined effort to clean
out the plastic swarf and put a little pressure on the tank to see what
would happen. The slight pressure I put on the tank must have blown out the
thin latyer and I got a little puff of air from a direction I wasn't
expecting, then I noticed the hole.
Europa promptly replaced the tank at no charge, but had I not noticed it
prior to bonding in the cockpit module I think I'd have been one unhappy
camper! At the time, circa 2003 or so, Andy told me there had been 2 others
prior to mine found with similar holes.
Anyway, hope you find your problem and it's something simple to fix.
Regards,
John Lawton
Dunlap,TN (TN89)
Jabiropa N245E - Flying - 95.6 hours
_____
AOL at <http://www.aol.com?ncid=AOLAOF00020000000339> AOL.com.
-- Release Date: 22/03/2007 07:44
--
22/03/2007 07:44
|