Erich,
In my case, it took some gentle tapping with a 1 lb hammer on a block
of wood to press the tubing into place.
I compared the 110mm length of the tube to the length of the reamer
so I would know when I had the reamer in sufficiently far to allow
the tube to seat fully.
You can check my build site (see signature block). Go to Year #6 Q1
2007, page #3 for pics and some description.
Good building and great flying,
Bob Borger
Europa Kit #A221 N914XL, XS Mono, Intercooled 914, Airmaster C/S
http://www.europaowners.org/N914XL
(85%) tail kit done, wings closed, cockpit module installed, pitch
system in, landing gear frame in, rudder system in, outrigger mod in,
Fuselage Top on, lift/drag/flap pins in, wing incidence set, tie bar
in, flap drive in, Mod 70 done. Baggage bay in. Flaps & Main Gear
complete. Mod 72 complete. Working in - 24 Instrument Panel, 25
Electrical, 30 Fuel System, 32 Tail, 34 Door Latches & 35 Doors, 37
Finishing. Airmaster arrived 29 Sep 05. Seat arrived from Oregon
Aero. E04 interior kit has arrived and is being installed.
Installing the ROTAX 914, again.
3705 Lynchburg Dr.
Corinth, TX 76208
Home: 940-497-2123
Cel: 817-992-1117
|