Fellow Europaphiles,
I have just hung the engine (2nd time after Mod 72). I have looked
through the build manual, engine installation manual, Rotax
installation manual and searched the archives but have not been able
to locate any torque specifications for the M10x110 engine mount
bolts and M10 Binx nuts.
Can anyone provide the torque numbers for these for bolts/nuts?
TIA
Good building and great flying,
Bob Borger
Europa Kit #A221 N914XL, XS Mono, Intercooled 914, Airmaster C/S
http://www.europaowners.org/N914XL
(85%) tail kit done, wings closed, cockpit module installed, pitch
system in, landing gear frame in, rudder system in, outrigger mod in,
Fuselage Top on, lift/drag/flap pins in, wing incidence set, tie bar
in, flap drive in, Mod 70 done. Baggage bay in. Flaps & Main Gear
complete. Mod 72 complete. Working in - 24 Instrument Panel, 25
Electrical, 30 Fuel System, 32 Tail, 34 Door Latches & 35 Doors, 37
Finishing. Airmaster arrived 29 Sep 05. Seat arrived from Oregon
Aero. E04 interior kit has arrived and is being installed.
Installing the ROTAX 914, again.
3705 Lynchburg Dr.
Corinth, TX 76208
Home: 940-497-2123
Cel: 817-992-1117
|