Karl
you might get the TP5 out with heat but the TP6 is not so easy. Even
after it is loose from the end rib you then have to get it inserted into
the root rib and then get it out of that.
The heat to loosen it from the end rib will almost certainly melt the
foam to an unknown extent, not worth the risk.
Graham
Karl Heindl wrote:
>
>
> Jeff,
>
> I think that the TP5 and TP6 can be removed with heat without cutting
> any holes. Also, it would be easier to pre-drill the pip-pin holes, as
> you can then do a trial fit before bonding. To get the position exactly
> right I would attach a template (using double-sided tape) with a 1/4
> inch hole over the top of the recess, first lining up all 3 holes with a
> 1/4 inch shaft or bolt, before removing the TP6. Just one of my crazy
> ideas.
>
> Karl
>
>
|