Bob, Your attention most appreciated..... I think it's the size of hole I made
because both copies snapped in two (ring in hole and centre piece separated).
I hope we are talking about the same size/kind of rivnut (from AS&S) which are
low profile tops and - #8 - about 0.250" just under that top. I found only
Bollhoff pages to describe them and they are not the same size as I bought.
Apparently
Bollhoff bought out Rivnut Indiana in 2001 - and they didn't ask any
of us permission.
I used SS #8 bolts with double washers and SS nuts, but sense the
rivnuts
must be PULLED not twisted up into themselves, and don't have the tool - maybe
that's the answer.
Anyway, awaiting your message with anticipation!
Cheers, Ferg
Visit - www.EuropaOwners.org
|