europa-list
[Top] [All Lists]

Re: Europa-List: motorglider V-speeds and registration

Subject: Re: Europa-List: motorglider V-speeds and registration
From: ALAN YERLY <budyerly@msn.com>
Date: Thu, 27 Sep 2007 12:46:16
Dave,
As the Europa US Distributor I have registered a number of Europas and 
have talked extensively with the FAA regarding registration of both 
wings.  

It is a piece of cake, and the EAA has an excellent series of downloads 
on how to fill out the forms.
Notes:  
Register the aircraft as an airplane!  Not a motorglider.
Your DAR should by now have direction on the limitations for your 
fly-off with both wings.
    They are in a nutshell:  Fly with short wings the 40 hours (Clear 
your Stage 1).   Then fly an additional 5-10 hours depending on your DAR 
to establish the characteristics with the long wings (when adding glider 
wings later, your initial airworthyness restrictions on where to fly are 
considered and may be re-imposed).  

You do not need to dual register the aircraft, that is the pilot rating.
I talked with the FAA senior trainer for DARs regarding the Europa dual 
wing and pilot registration problems.  If your DAR has a problem, he can 
call Brad Outlaw or Les Sargent at the FAA (Brad is the senior trainer 
for QC) and Brad will give him the straight skinny.

I am attaching the Motorglider Pilot Handbook for you to download and 
print.  All the numbers are there.

I have suggested an operational limitation for the airbrake opening for 
one pilot due to his experience as his airbrakes tend to flutter just as 
you crack open the airbrakes above 100KIAS.  Once deployed they are 
smooth.  As a result of being harder to deploy above that speed and 
personally, the resultant pitch down associated with them at speed and 
the force to hold them open is a nuisance, so we limited his aircraft to 
near normal flap lowering speeds of 85 KIAS because for him they are 
mainly used in the pattern rather than high speed descent.  The motor 
glider is deceptively fast.  When built light and at low altitude (1500 
feet) and 75% power on a Rotax 912S you will cruise near 110-115 KIAS.  
One updraft and a little push over and you are over 120 in a heartbeat.

As for marking, the FAA was amenable to dual markings.  This presents a 
problem for EFIS equipped aircraft as the devices show only one set of 
speeds.  Perhaps your DAR will allow a placard next to the EFIS if so 
equipped.

In my experience with the three motor gliders I have helped construct, 
the CG shifts forward about .75 to 1.0 inch with the glider wings.  Yes, 
you must do another weight and balance.  Typical weight increase is 100 
pounds.  (It was more of a reason to diet.)

CG will determine if you achieve a stall or if it is nose heavy, where 
full aft stick limit is achieved.  CG limits are the same for both wings 
and the aircraft flies best, in my opinion, with the long wings at about 
60 inches empty.  I have only gotten down to 55 KIAS full aft stick due 
to forward CG on the aircraft tested (59.25 inch).

I am posting, at my own dread, my rant on Vne to another builder.

My background is a military fighter pilot and a Functional Test Pilot 
(the guy who gets stuck flying the aircraft after a complete teardown or 
problems with aircraft handling or the stability and control systems) 
and as such have some experience in taking aircraft routinely to their 
design limits of airspeed and G to assure proper operational safety.  I 
am also an Aeronautical Engineer (Parks '72) and an avid EAAer.  So here 
is my rant edited for children and sensitive adults:

Airbrake extension is Vne but I find 85 knots to be most comfortable as 
they can vibrate on opening and closing above 100KIAS.

Vne 129 KIAS
Vlg is 83 KIAS (Gear and Flaps came down together right!)  
No idea what is maneuvering above 1370.  You must pull max G and achieve 
the stall simultaneously to find the value to determine Vmanuever.  
RE G limit
You must lower your G proportionately above 1370 lbs due to 
wing/airframe stress.
I interpolated some a long time ago and made a placard in excel for 
someone.  Hope the cut and paste is readable.

      STRUCTURAL LIMIT:  +3.8g / -1.9g at 1370lbs. 
      +3.5g / -1.5g at 
      1450 lbs. 
      +3.3g/-1.3 at 
      1550 lbs.

     

The landing gear has only been drop tested to 1370.  You should drop 
your aircraft 12 inches at the max landing weight you are redesigning to 
for verification.  

Added Note:  The trigear legs move a lot at 1550 pounds.  It will get 
your attention.  The monowheel squats even more. 
Yes I have flown the aircraft over gross, but very gently and got away 
with it.  I don't do it on a routine basis and don't recommend it.  
Although someone has flown their personal aircraft beyond the limits, 
that doesn't mean yours will do the same.  Every builder has different 
standards and conditions on building his aircraft.  That's why 
production aircraft have quality control procedures but, we kit builders 
in the US are not blessed or affected by them, only our personal QC.


The Glider POH is attached but is not PFA approved or edited as of this 
printing.  The PFA has still not certified the wings because of the the 
PFA getting to it, but all the testing has been completed and 
adjustments made years ago.  John and Roger at the factory are pushing 
them as hard as they can.

As for Vne.  It is the value determined by the engineers and test pilots 
together.
It is generally an indicated airspeed or a mach number (some of the new 
all glass biz jets display the limit on the TAS display but it is really 
a mach limit).  

Added Note:  Mach varies primarily with temperature, therefore it is 
altitude dependent.  Mach and TAS are proportional in that .8 Mach is 
480 KTAS at F-4 cruise altitudes to within a couple of knots.  See the 
note on your E6B computer and test it yourself.  Wing design (camber and 
sweep) determine Mach crit.  The aircraft shape and planform determine 
the effects of Mach crit.  

Vne is determined by the design limit, the Q limit (dynamic pressure) 
and the structural anomalies such as flutter, wing divergence, 
windscreen implosion, tail plane effectiveness due to critical mach, 
etc.  The value must be read by the pilot with basic flight instruments 
provided by the manufacturer.  It is also affected by the gust factor 
and other government  imposed guidelines on designers.  Allowances are 
made, and some safety factors are involved but not printed for public 
use.  Vne has never been a TAS limit in any design class or aircraft I 
have flown.  The airplane only feels indicated airspeed (dynamic 
pressure) and mach effects period.  

The T-38 is limited by the Q on the windscreen,
The T-33 by the mach crit.
The F-4 by the longitudinal stability and radome Q limit (heat and 
pressure)

You guys are too much into details on the internet.  All you guys need 
to know is it is the limit that is imposed, by one of the factors deemed 
important.  

Bottom line:  Limits are limits.  Boldly going beyond them is to be 
avoided.  Changing the operational limits of an aircraft must go back to 
the manufacturer.  By the way Mr. Mac's engineers built the F-4 to meet 
a certain spec and said, if you need more G, it will cost you!

There are old pilots and bold pilots, but no old bold pilots....I have 
been to their funerals.  Build a Europa light and by the book and the 
aircraft will give you what we have found to be a delightful sport 
aircraft.  If you must change your aircraft, seek paid professional help 
willing to stand by their recommendations.  Kit manufacturers which open 
up actual test results expose themselves to assumptions that a novice 
may make in a modification to the construction of his aircraft or its 
operation.

All manufacturers learn and improve their products through field 
experience.  That is why I respect the Europa Club and their approach to 
aircraft mods.  The UK owners are limited by PFA guidelines, but work 
within the system to make the product better.  And all the manufacturers 
listen.  We in the states have more latitude and it is forums like this 
where we can find out what has worked and what was done to make it work. 
 Sorry for the rant.  Keep asking questions and doing the research.  
Those of us who can help on these forums generally do.  I lost two hours 
of shop time putting together emails such as this, and I can't afford to 
do it as often as I would like to weigh in.  Looks like I will be 
working late tonight.

I hope this has helped and please call if you get stuck on registration.

Off my soapbox now, 

Bud Yerly
Custom Flight
813 653 4989
www.customflightcreations.com<http://www.customflightcreations.com/>


  ----- Original Message ----- 
  From: David DeFord<mailto:davedeford@comcast.net> 
  To: europa-list@matronics.com<mailto:europa-list@matronics.com> 
  Sent: Tuesday, September 25, 2007 9:59 PM
  Subject: Europa-List: motorglider V-speeds and registration


<davedeford@comcast.net<mailto:davedeford@comcast.net>>

  We are just about ready for paint on our motorglider wings, and we 
have a
  few questions for other motorglider operators.

  1. What are the expected stall speeds with the long wings, what are 
Vno and
  Va, and what is the limiting speed for airbrake extension (if any)? 

  2. How have people marked their airspeed indicators to show values for 
both
  short wings and long wings?  Two concentric sets of arcs?

  3. What are the C.G. limits with long wins?

  4. Any hints for convincing the FAA to grant registration in two 
categories
  (ASEL and self-launch glider), depending on which wings are installed? 
 We
  have been flying with the short wings for 6 years, so a change from 
the
  existing category and operating limitations will be required.

  5. Keeping potential controversy for last, how does Vne vary with 
altitude?
  (The Diamond Extreme in which Terry and I recently got our self-launch
  glider ratings has a placard which derates Vne from the marked value 
at 6500
  feet by exactly the same ratios as shown in the table for the 
Pipistrel
  Sinus, referenced in the article recently posted by Richard Pottorff.)

  Thanks.

  Dave DeFord
  N135TD


http://www.matronics.com/Navigator?Europa-List<http://www.matronics.com/N
avigator?Europa-List>



<Prev in Thread] Current Thread [Next in Thread>