> We cut this console down but added several layers of bid to reinforce
> the inside. We then created the top with 5 layers of bid. It's secured
> with #10 screws and nut plates. The left seat was widened by
> reshapeing the left side of the console to allow for more leg room.
> This was done with 3 layers of bid over a center of 1/4 inch foam
> shaped to allow a right leg more room. As you can see it makes a great
> arm rest and a lot more room for toys. The fuel filters are located
> right under the arm rest and can be viewed in flight anytime.
Jeff...what an absolutely elegant mod...I salute you. I take it all
this was done prior to CM installation...(?)
Fred
A194
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
|