Hi Svein,
I have a towbar and fittings attached to the nose gear.
I had two pieces of approx 1.5 inch aluminium rod recessed on one side
with a hole through the center. These are attached to the nose wheel
axle with the existing bolt, and the fairing cut to allow them to
protrude slightly. The tow bar is made of steel tube with a piece of
tube at each side of the attachment end sized to match the recess size
in the aluminium collars. The towbar is in two parts which slide
together to enable the attachment, then pinned to retain.
Hard to describe but if you want a photo, please let me know.
Geoff Leedham
G-EOFS 914 Trigear
----- Original Message -----
From: Sidsel & Svein Johnsen
To: Europa List
Sent: Thursday, October 25, 2007 7:25 AM
Subject: Europa-List: Nose wheel towbar and attachment
Does anyone have a proven solution for a towbar and its attachment to
the nose gear?
I have the factory's wheel fairing installed.
Regards,
Svein
LN-SKJ
-------------------------------------------------------------------------
-----
23/10/2007 13:26
|