Hi Jeff,
Sorry I omitted the rest of the setup. At the throttle lever, each cable is
wrapped
around a cable bushing (Lockwood #2711 or 2710; ACS CF2710 - the catalogs
are a little confusing - you need one to fit AN3 bolt and .078 dia wire-pretty
sure it's the Lockwood 2711). You'll need two of them. Wrap the cable very
tightly as there isn't much room in the throttle lever housing. I secured the
ends of the cables with Cable End Fittings (Lockwood BR06 - or perhaps a
lawnmower
end from the local hardware store) and also used some Araldite for extra
security. Place one cable on either side of the throttle lever like the factory
setup. At the carb end, the Rotax supplied fittings will accommodate the
.078 wire.
Hope this helps.
Jim
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=150335#150335
|