I would put my money on this as the cause! I also have seen this and talked
to 912 and 914 drivers with the same. Tie all those wires tight after
fixing!
Jerry
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of JEFF ROBERTS
Sent: Wednesday, December 05, 2007 2:55 PM
Subject: Re: Europa-List: Rotax 912 run on
David,
I just went through this last summer and as Paul said it's probably at
the mags. The wire coming out of them is very cheep and needs a pig
tail of quality tefzel (Not sure of that spelling) wire. We then
soldered the ground wires direct to the pigtails and the problem has
never come back. Make sure you tie wrap the pigtails and put some
shrink tubing at the solder joint. Vibration is your enemy right at the
mag. A partially broken wire gave me fits until this list told me to
look there.
Regards,
Jeff R.
A258 - N128LJ / Gold Rush 96 hours and climbing slowly.
|