if you are going the solder option to make them, i wrapped mine around a
piece of alloy tube to form them
soldered them up, slid off the end of the tube about 6mm then just pushed it
point first into the bench
to just close the end up enough to solder that. very quick and easy, then
you can redux them in right away
craig
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com]On Behalf Of flyingphil2
Sent: Sunday, 24 February 2008 3:19 AM
Subject: Europa-List: Finger Strainers
Hi,
I'm soon going to be making my coarse finger fuel strainers and wondered if
anyone had any comments on these or if they had made any changes.
I've done a search and there's a few comments but nothing else. I'm
assuming that everyone is pretty happy with them and if that's the case I'll
go ahead and make and fit them.
Thanks,
Phil
Visit - www.EuropaOwners.org
6:39 PM
6:39 PM
|