Fred,
I did just that. I also put a protection '2 x bid' layup under the
turnbuckles to protect the floor. I then fed the cables through a guide
either side of the push-rod containment stop raising the cables off the
floor less then 10 degrees angle.
Turnbuckles are good although I must say I haven't adjusted them much (only
once) with 160 hours flying, however they do allow you to correct the
steering alignment.
Cheer,
Tim
Tim Ward
12 Waiwetu Street,
Fendalton,
CHRISTCHURCH 8052
NEW ZEALAND
Ph :64 03 3515166
Mob: 021 0640221
email:
ward.t@xtra.co.nz
----- Original Message -----
From: "Fred Klein" <fklein@orcasonline.com>
Sent: Tuesday, February 26, 2008 6:46 PM
Subject: Europa-List: RE: RUDDER CABLES
>
> On this topic, I'm intending to install a pair of turnbuckles to enable
> tension adjustment. For ease of access, I would be placing them just aft
> of the removable "D" panel in the baggage bay bulkhead. Would anyone offer
> a comment or two on this issue? Perhaps I'm overlooking something...
>
> Thanks,
>
> Fred
> A194
>
>
> --
> This message has been scanned for viruses and
> dangerous content by MailScanner, and is
> believed to be clean.
>
>
>
|