>You mix the redux a little on the thick side using flox, then coat
>the ribs only. You then put strips of visqueen over them and
>install and weight the skin
Folks - see my journal entry & linked pictures for 16 November 2007
for a graphic illustration of this on my port wing - go to
<http://home.clara.net/rowil/aviation/200711.html>
I've just done the starboard wing in the past week and it displayed a
different set of rib height variations, so pre-bonding was definitely
worthwhile for me.
I endorse Neville's advice about using the strip of vinyl as a spacer
too - anything thinner would have needed excessive trimming to get my
aileron travel up to spec.
Hope this helps.
regards
Rowland
--
| Rowland Carson LAA #16532 http://home.clara.net/rowil/aviation/
| 990 hours building Europa #435 G-ROWI e-mail <rowil@clara.net>
|