Colin,
I am not sure if it was The Optimum Pos,
but anyway I installed it (Dynon remote compass)
behind the D-panel under the stabilator tube (middle).
Under the remote compass I made a special aluminium bracket
which was both ways *absolutely* levelled when the plane was supported
to the flevel flight position.
I glued it to the floor by Sica mass.
The remote compass is fixed to the bracket w Nylon screws and nuts
- so no any magnetic metal near by. Nylon screws are positioned such a
way that it is possible to make some minor adjustments to reposition the
remote compass.
Seems to work well. If necessary I can take a pic and send it to you.
BTW my Dynon=B4s OAT sensor is located far behind the remote compass.
Raimo
----- Original Message -----
From: colin smallwood
To: matronics
Sent: Wednesday, May 14, 2008 10:53 AM
Subject: Europa-List: Dynon D10 Remote compass Position
Hi All
Help please!
Finally calibrating the DI on my D10.To save laptops
in flight the remote compass is to be installed
Any one fitted the remote compass and if so where
was the optimum position? Thanks in anticipation
Regards
Colin Smallwood G-DEBR
|