Elbie
just a though, sure, shows are expensive but it is cheaper for you that
all your customers visit you at a show than you go and visit them ;-)
I'm impressed with your description of the "poor man's HUD" btw
Graham
EMAproducts@aol.com wrote:
> No offense taken Ferg!
> I have never produced an AOA with a needle & Dial, though did some
> experimenting with them for many years, from the late 60's to
> '91 prior to going to LEDs I attended Sun N Fun , Oshkosh, Arlington
> having a booth and giving forums from about 96 to '05 and finally
> decided the shows were so expensive that unless I really raised the
> price of my product it wasn't worth the cost & effort. Not that I
> didnt' like going to the shows, but the reality crept in that it
> wasn't helping the bottom line any. I have advertised in the Sport
> Aviation and Experimenter for well over 10 years, could be that isn't
> very productive either :-)
> Our "Poor Mans HUD" is basically just that we use Ultra bright LED's,
> bury under the glare shield, and angle so the LED's are reflected on
> the windscreen, works just as good as the multi thousand dollar
> system. Think of it, anything you lay on the panel reflects ~~ right
> where you want to look! All you see in the windscreen is a little
> series of colored dots, all 3 green you are on speed, amber slow, red
> stall warning.
> Will answer other questions off line, don't want to interfere with the
> main purpose of these lists, helping the builder This can be refined
> with a short tube to make the light more intense and sharply defined.
> I'm still striving to give the best safety product at the lowest price.
> Elbie
> www.riteangle.com <http://www.riteangle.com>
>
>
>
>
>
>
|