A couple of responses.
In my experiments, I think some fuel leaked out of the ends but some also must
have gone through the wall of the tubing. Then ends were plugged with 1/4" rods
and a plastic clamp. Any scratch on the rod would allow leakage.
I have Tony K's fuel gauge documentation. I can email it if anyone wants it.
I just used the sensor and an op amp to make a sensor that puts out 0-5 VDC
based
on pressure. I also have a schematic of that if anyone wants that.
Jim Butcher
N241BW
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=196382#196382
|