I am in the process of doing the wing tie bar.
I followed the book religiously and note that it tells you to put in the
gear legs and the ribs that support them.
Two questions
1. how do you deal with the tie bar and the gear support ribs. The manual
tells you to allow for the tie bar with an angled depression in the ribs.
Does this weaken the uni which goes along the top of the ribs? Also there
does seem to be enough space to angle the rib around the tie bar.
2. the ply block between the cockpit module and the tie bar has to be
fiberglassed to the cockpit module - after the gear legs. So I am assuming
that the bid goes over and wrapped around the gear legs. Am I right?
How did anyone else do this?
Will
PS I note with slight worry that the rear wing attachment pin is vertical
with respect to the wing chord but not with respect to the fuse. Is this
all right?
Checked by AVG.
07:16
|