Hi Paul,
This from the Reiff Website:
"The only Thumbs Down we got was The Reiff sump pad proved difficult to install,
due to adhesive bonding problems.. The problems described were not the fault
of the J-B Weld epoxy, but of improper curing. The article states After two
hours we turned on the element to accelerate the cure. However, our
Installation
Instructions indicate Do not plug in the heater to cure J-B Weld . Excessive
heat ruins the cure."
Sounds like JB-Weld!
--------
Ira N224XS
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p 8372#208372
|