Tesy message - I cant remember my usedr name!
2009/1/4 Erich Trombley <erichdtrombley@juno.com>
> erichdtrombley@juno.com>
>
> Paul,
>
> I have been using the blue silicone heater hose for several years now
> without issue. While I do not have the spring type clamps I found that
> slipping heat shrink tubing over the standard worm drive hose clamps works a
> treat. Without the shrink tubing you will run the risk of the clamp cutting
> into the silicone. Additionally, I used heat shrink tubing over the end of
> the silicone hose to minimize any chance of chaffing from the clamp.
> Finally, as I concerned about the hose kinking as it came up and over the
> top of the engine I wrapped the outside of hose in that location with safety
> wire in a loose spiral then covered it with shrink wrap to keep it in place.
>
> Also, I know of one other builder that used silicone vacuum line with great
> success. Both items are available at:
>
> http://www.paragonperformance.com
>
> Regards,
>
> Erich Trombley
> N28ET Classic Mono 914
>
> ____________________________________________________________
> Click here for free information on nursing degrees, up to $150/hour
>
> http://thirdpartyoffers.juno.com/TGL2131/fc/PnY6rbu0vDKdYORnAPlOjhWoO5WAOiEiV1nHPreLv1T2gtxsdsBbR/
>
>
|