Thanks for the replies everyone. Good to know it's normal.
Yes Bill, nearly ready to fly ! Haven't run the engine yet, but all else
complete - all the electrical systems seem to work - Amazing
Regards,
Keith Hickling,
New Zealand.
XS ZK MEE
----- Original Message -----
From: Bill Sisley
To: europa-list@matronics.com
Sent: Saturday, January 24, 2009 8:50 AM
Subject: Re: Europa-List: Rotax Flydat
Keith,
Mine does the same, a feature of the unit.
Hear on the grapevine you are nearly ready to fly!!!!!!!!
Cheers
Sue & Bill Sisley
Keith Hickling wrote:
On firing the starter motor for the first time to check the oil
pressure after priming the oil system, my Rotax Flydat screen went
blank, then after turning off the starter motor it cycled through the
initial start-up screens twice before returning to the normal display.
This happened repeatedly on running the starter motor.
Can someone with a flydat tell me if this is normal? And if not
normal does it risk damaging the unit if it is caused by sudden voltage
changes? Should it be switched off when starting the engine?
Thanks,
Keith Hickling,
New Zealand.
href="http://www.matronics.com/Navigator?Europa-List";>http://www.matron
ics.com/Navigator?Europa-List
href="http://forums.matronics.com";>http://forums.matronics.com
href="http://www.matronics.com/contribution";>http://www.matronics.com/c
ontribution
|