I need to get the following plumbed to my short (XS Monowheel) wings:
PORT:
Pitot
Static
AOA
Position LEDs
Strobe
roll servo
Landing LED
STARBOARD:
Factory stall warner tube
Position LED
Strobe
Taxi
LED
What location has been used with success?
I have
a conduit in center of ribs aft of spar to run all of the above.
Considering the following:
****Using Europas recommended entry just
forward of fuse spar hole near top (this means stuff needs to be routed
above spar
****Routing some stuff below fuse spar hole, and
being very careful drill a hole just aft of spar hole near bottom sneaking
between fuel tank and aileron bracket (this will have stuff aft of
spar)
****Entering just aft and above rear lift pin (This will
require drilling a hole close to the all too crucial rear lift pin
layup)
Any other input is most welcomed.
Thx.
Ron Parigoris
|