Troy,
Use this information with a grain of salt as I have the XS model.
On the starboard side I measured 275mm from the window ledge down to the top
of the plate. Then 355 down to the bottom of the plate. Then from the back
of the seat as seen through the wing spar hole to the near plate edge measured
40mm and 130 mm to the far side of the plate. I measured the plate to be
75mmX 75mm square. These measurements were the same of the port side when
measured.
Just for S&G, I used my stud finder and was easily able to find the edges of
the top, bottom, and forward side. The only side I had a problem with was
the side nearest the wing spar hole because of the buildup of plies for
re-enforcement.
Give it a try with your stud finder first, mark the edges, then check with
the measurements.
Mike Duane A207A
Redding, California
XS Conventional Gear
Jabiru 3300A
Sensenich R64Z N
Ground Adjustable Prop
**************Feeling the pinch at the grocery store? Make dinner for $10 or
less. (http://food.aol.com/frugal-feasts?ncid=emlcntusfood00000001)
|